NHP Power System LLP
Hadapsar, Pune, Maharashtra
GST No. 27AAKFN4046M1ZU
TrustSEAL Verified
Call 0804603509974% Response Rate
SEND EMAIL
Product Details:
| Brand | NHP |
| Output Voltage | Float Mode: 13.3V to 13.5V DC; Boost Mode: 13.8V to 14V DC |
| Input Voltage | 170V to 270V AC |
| Output Current | Float Mode: 0 to 3 Amps; Boost Mode: 10 Amps |
| Cooling Method | Naturally Air Cooled |
| Dimensions: LBH | 187*58*131mm |
| Mounting | Wall mounting type |
| Input Specifications: | |
| Input Voltage | 170V - 270V AC |
| Input Voltage Frequency | 40Hz to 65Hz |
| Input Current | 1A Typical at 230V AC |
| Input Inrush Current | Limited by NTC Thermistor to 35A |
| Leakage current | <2 mA at 230V AC |
| Output Specifications: | |
| Output voltage: | Float Mode: 13.3V to 13.5V DC; Boost Mode: 13.8V to 14V DC |
| Charging current in boost mode | 10 amps |
| Charging current in float mode | 0 amps to 3 amps |
| Line Regulation | <1% |
| Load Regulation | <1% |
| Ripple and noise | 150 mv p-p |
| Stand-by Power Consumption | 3W |
| Protections: | |
| Input under voltage | Cutoff level 140V AC; Turn on voltage 160V AC |
| Input over voltage | 320V AC units shuts off if voltage goes above this value and automatic restart when input is less than 275V AC |
| Output over voltage (Battery charger included) | 15V DC |
| Output short circuit and overload | Continuously Protected |
| Battery reverse polarity | Protected |
| Current drawn by charger from battery | Draws zero current from the battery under any circumstances |
| Externally Induced Over voltage | Protected against output over-voltage caused by parallel connection of alternator, etc. |
| Annunciation | Potential free NO/NC contact for charger ON/Fail indication |
Additional Information:
Product Details:
| Brand | NHP |
| Part Number | NHP-BC-24-2.5-A |
| Number of Batteries Charged | 1 OF 24V 10Ah TO 25Ah RATING |
| Input Voltage | 100 to 270VAC |
| Output Voltage | 28.2VDC to 27.8VDC |
| Output Current | 0 - 2.5A |
| Make | NHP |
| Product Code | NHP-BC-24-2.5-A |
Salient Features:
· Surge immunity up to 7KV
· Two phase protection
· Wide operating range
· Draws zero current from battery when mains is off
· Can be connected in parallel with the alternator
· High reliability
· Two stage charging
Additional Information:
Product Details:
| Brand | NHP |
| Part Number | NHP-BC-24-15-A |
| Output Voltage | 24V |
| Number of Batteries Charged | 1 Battery of 24v 75Ah to 150 Ah |
| Battery Type Charged | Lead Acid |
| Float Current | 0-5A |
| Boost Current | 15A |
| Hold Up Time | 20Msec(230Vac And Fl ) |
| Effeciency | 85% |
| Operating Temperature | -20 To 50 Degree C |
| Humidity | 20-90 RH Non Condensing |
| Load Regulation | Better Than 1% |
Product Details:
| Brand | NHP |
| Model No | NHP-BC-24-5-A |
| Float Voltage | 26.2V DC - 26.5V DC |
| Boost Voltage | 27.8V DC - 28.2V DC |
| Float Current | 0A - 2.5A |
| Boost Current | 2.5A - 5A |
| Output Power | 112 W |
| Efficiency | 85 % |
| Frequency Range | 40-60 HZ |
| Line Regulation | Better than 1% |
| Load Regulation | Better than 2% |
| Input Voltage Range | 170-270VAC |
| Inrush Current | 35A(230VAC) |
| Operating Temp | -20 to 50 deg C |
| Humidity | 20 ~ 90 RH Non Condensing |
| Storage Temp | -20 to 85 deg C |
| Dimensions | 185mm x 60mm x 113mm |
| Footprint | 185mm x 60mm |
Product Details:
| Brand | NHP |
| Input Voltage | 150-300 V AC |
| Charging Current In Boost Mode | 6 amps |
| Charging Current In Float Mode | 0 to 2.5 amps |
| Operating Temperature | 0 to 50 deg C |
| Leakage Current | Less than 2 mA at 230 vac |
| Float Mode Output Voltage | 13.4 V DC |
| Boost Mode Output Voltage | 13.9 to 14 V DC |
| Vibration | 10-500 Hz 2G 10 min/1cycle 60 mins each along XYZ axis |
| Line Regulation | <1% |
| Load Regulation | <1% |
| Ripple and noise | 150 mv p-p |
| Isolation between Input and Output | 2000V AC |
| Input and Earth | 1500V AC |
| Output and Earth | 1500V AC |
| Dimensions | 170x110x60 mm |
| Mounting | Wall mounting type |
| Weight | 1000 gms |
Product Details:
| Brand | NHP |
| Output Voltage | 24V |
| Output current | 30A |
| Float Current | 0 - 6A |
| Boost Current | 6 - 30A |
| Cooling | Forced Air |
| Effeciency | Greater than 85% |
| Load Regulation | Better than 1% |
| Line Regulation | Better than 1% |
| Vibration | 10-500 Hz 2G 10 min/cycle 60 mins each along X,Y,Z axis |
| Dimensions | 266*120*115mm |
| Input Specifications: | |
| Input Voltage | 170V - 270V AC |
| Input Voltage Frequency | 40Hz to 65Hz |
| Input Current | 5A Typical at 230V AC |
| Input Inrush Current | Limited by NTC Thermistor to 35A |
| Leakage current | <2 mA at 230V AC |
| Output Specifications: | |
| Output voltage: | Float Mode: 26.2V to 26.5V DC; Boost Mode: 27.8V to 28.4V DC |
| Charging current in boost mode | 6 amps to 30 amps |
| Charging current in float mode | 0 amps to 6 amps |
| Line Regulation | <1% |
| Load Regulation | <1% |
| Ripple and noise | 250 mv p-p |
| Stand-by Power Consumption | 3W |
| Protections: | |
| Input under voltage | Cutoff level 140V AC; Turn on voltage 160V AC |
| Input over voltage | 320V AC units shuts off if voltage goes above this value and automatic restart when input is less than 275V AC |
| Output over voltage (Battery charger included) | 30V DC |
| Output short circuit and overload | Continuously Protected |
| Battery reverse polarity | Protected |
| Current drawn by charger from battery | Draws zero current from the battery under any circumstances |
| Externally Induced Over voltage | Protected against output over-voltage caused by parallel connection of alternator, etc. |
| Annunciation | Potential free NO/NC contact for charger ON/Fail indication |
Additional Information:
Product Details:
| Brand | NHP |
| Output Voltage | Float Mode: 13.3V to 13.5V DC; Boost Mode: 13.8V to 14V DC |
| Input Voltage | 170V to 270V AC |
| Output Current | Float Mode: 0 to 3 Amps; Boost Mode: 10 Amps |
| Dimensions: LBH | 187*58*131mm |
| Mounting | Wall mounting type |
| Cooling Method | Naturally Air Cooled |
| Input Specifications: | |
| Input Voltage | 170V - 270V AC |
| Input Voltage Frequency | 40Hz to 65Hz |
| Input Current | 1A Typical at 230V AC |
| Input Inrush Current | Limited by NTC Thermistor to 35A |
| Leakage current | <2 mA at 230V AC |
| Output Specifications: | |
| Output voltage: | Float Mode: 13.3V to 13.5V DC; Boost Mode: 13.8V to 14V DC |
| Charging current in boost mode | 10 amps |
| Charging current in float mode | 0 amps to 3 amps |
| Line Regulation | <1% |
| Load Regulation | <1% |
| Ripple and noise | 150 mv p-p |
| Stand-by Power Consumption | 3W |
| Protections: | |
| Input under voltage | Cutoff level 140V AC; Turn on voltage 160V AC |
| Input over voltage | 320V AC units shuts off if voltage goes above this value and automatic restart when input is less than 275V AC |
| Output over voltage (Battery charger included) | 15V DC |
| Output short circuit and overload | Continuously Protected |
| Battery reverse polarity | Protected |
| Current drawn by charger from battery | Draws zero current from the battery under any circumstances |
| Externally Induced Over voltage | Protected against output over-voltage caused by parallel connection of alternator, etc. |
| Annunciation | Potential free NO/NC contact for charger ON/Fail indication |
Additional Information:
Product Details:
| Brand | NHP |
| Output Voltage | Float: 26.2V DC - 26.5V DC; Boost: 27.8V DC - 28.4V DC |
| Input Voltage | 170-270V AC |
| Dimensions | 190mm x 73mm x 130mm |
| Efficiency | Greater than 85% |
| Output Power | 280W |
| Footprint | 190 mm x 73 mm |
| Ripple | 250mV p-p |
| Output Current | Float: 0A - 3A; Boost: 3A - 10A |
| Line Regulation | Better than 1% |
| Load Regulation | Better than 2% |
| Leakage Current | Less than 3.5ma |
| Operating Temperature | -20 to 85 Deg C |
| Humidity | 20 to 90% RH |
| Storage Temp | -20 to 85 Deg C |
| Input Specifications: | |
| Input Voltage | 170V - 270V AC |
| Input Voltage Frequency | 40Hz to 65Hz |
| Input Current | 2.6A Typical at 230V AC |
| Input Inrush Current | Limited by NTC Thermistor to 35A |
| Leakage current | <3.5 mA at 230V AC |
| Output Specifications: | |
| Output voltage: | Float Mode: 26.2V to 26.5V DC; Boost Mode: 27.8V to 28.4V DC |
| Charging current in boost mode | 10 amps |
| Charging current in float mode | 0 amps to 3 amps |
| Line Regulation | <1% |
| Load Regulation | <1% |
| Ripple and noise | 250 mv p-p |
| Stand-by Power Consumption | 3W |
| Protections: | |
| Input under voltage | Cutoff level 140V AC; Turn on voltage 160V AC |
| Input over voltage | 320V AC units shuts off if voltage goes above this value and automatic restart when input is less than 275V AC |
| Output over voltage (Battery charger included) | 29V DC |
| Output short circuit and overload | Continuously Protected |
| Battery reverse polarity | Protected |
| Current drawn by charger from battery | Draws zero current from the battery under any circumstances |
| Externally Induced Over voltage | Protected against output over-voltage caused by parallel connection of alternator, etc. |
| Annunciation | Potential free NO/NC contact for charger ON/Fail indication |
Additional Information:
Product Details:
| Brand | NHP |
| Part Number | NHP-BC-24-20-A |
| Operating Temperature | -20 To 50 Degree C |
| Output Voltage | 24V |
| Number of Batteries Charged | 1 Battery of 24v with 100Ah to 200 Ah rating |
| Battery Type Charged | Lead Acid |
| Float Current | 0 - 5A |
| Boost Current | 5 - 20A |
| Humidity | 20-90 Rh Non Condensing |
| Vibration | 10 To 200Hz 2.5G 10 Min |
| Efficiency | 85% |
| Load Regulation | Better Than 2% |
| Termination | Terminal Blocks |
Product Details:
| Country of Origin | Made in India |
| Brand | NHP Power |
| Maximum Output Current | 5A |
| I Deal In | New Only |
| Input Specifications: | |
| Input Voltage | 170V - 270V AC |
| Input Voltage Frequency | 40Hz to 65Hz |
| Input Current | 1A Typical at 230V AC |
| Input Inrush Current | Limited by NTC Thermistor to 35A |
| Leakage current | <2 mA at 230V AC |
| Output Specifications: | |
| Output voltage: | 13.8V to 14V DC |
| Charging current | 5 amps |
| Line Regulation | <1% |
| Load Regulation | <1% |
| Ripple and noise | 150 mv p-p |
| Stand-by Power Consumption | 3W |
| Protections: | |
| Input under voltage | Cutoff level 140V AC; Turn on voltage 160V AC |
| Input over voltage | 320V AC units shuts off if voltage goes above this value and automatic restart when input is less than 275V AC |
| Output over voltage (Battery charger included) | 15V DC |
| Output short circuit and overload | Continuously Protected |
| Battery reverse polarity | Protected |
| Current drawn by charger from battery | Draws zero current from the battery under any circumstances |
| Externally Induced Over voltage | Protected against output over-voltage caused by parallel connection of alternator, etc. |